Scion xB Forum banner
Status
Not open for further replies.

Endlink Bushings

1.5K views 14 replies 6 participants last post by  hotbox05  
#1 ·
can anyone shed some light on endlink bushings?

what does it do?
is it worth it?
any noticeable difference?
how hard is this to install?
what sizing do you have to use for the xb?
is this where babies come out?
 
#2 · (Edited)
they go on the front sway bar there the bushings that go inbetween the swaybar bolts at each end theres usually 4 to each side. there not hard to change out / try to find some urathane ones it will stiffin up the front takes all the slack out of the front sway bar / i know auto zone had them not sure if they still do tho
 
#8 ·
#9 ·
Spiderbox said:
so i will need 4 sets of 4?

whats the difference between the hourglass shaped one and flat ones?
is there a specific size I need to get?

wait a second whats the difference between this http://store.summitracing.com/partdetail.asp?autofilter=1&part=ENS-9-8122R&N=700+0&autoview=sku

and this ?
http://store.summitracing.com/partdetail.asp?autofilter=1&part=ENS-9-8126R&N=700+115&autoview=sku
Just buy this set.
wait a second whats the difference between this http://store.summitracing.com/partdetail.asp?autofilter=1&part=ENS-9-8122R&N=700+0&autoview=sku
There is no difference in the bushings in either picture.
 
Save
#10 ·
^^^ Them better be the right ones, I just ordered them! ;)

I was needing this info a couple months ago, thanks!
 
Save
#11 · (Edited)
look closer

one is just bushings(use old hardware)
one is bushings, nuts, and bolts:D
check that measurments are for xb
bush o.d.
bush i.d.
bush length
 
Save
#14 ·
I'm too lazy and I don't have time. They should be sending mine out today.
 
Save
Status
Not open for further replies.
You have insufficient privileges to reply here.