Scion xB Forum banner

Status
Not open for further replies.
1 - 15 of 15 Posts

·
Registered
Joined
·
326 Posts
Discussion Starter #1
hello everyone i am heading to asia on the 9th. of sept. i will be trying to find a place to produce camber shims . i want to know what the people want. what degree camber are u guys looking for. hopefully i will be able to sell them for around $100 maybe even cheaper not including bolts. i will have to find a source in fl for the bolts. want to know what you guys think.

thank you for reading

nippon
i am trying to contribute to the site by bringing quality stuff at a price we can afford. hopefully i will find a place to build my camber shims.

p.s. please just put what degree u would like not to many comments
 

·
Registered
Joined
·
19,896 Posts
AirecK said:
some for the front....
come on!!!!
exactly!!! i wanna run -5 up front too without buying plates and bolts!!
 

·
NEXT LEVEL MOTORING
Joined
·
3,810 Posts
mplayaz9 said:
does cusco make them for front and back?.. and otg only come for the back right?
1. cusco-front
2. otg-back

you can git the cusco front upper camber plates from matty.
you can git the -3 rear camber shims from otg.
you can git the -1.5 front camber bolts from ryan @ www.nlmotoring.com

or, you can git them all from ryan @ www.nlmotoring.com (call thier 800 # on thier site)
 

·
Nor*Cal's Most Hated
Joined
·
3,841 Posts
I've been seriously considering running at least neg 5 in the rear now.
 
1 - 15 of 15 Posts
Status
Not open for further replies.
Top