Scion xB Forum banner

Status
Not open for further replies.
1 - 9 of 9 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter #1
not a big or hard mod but here it is--
1- cut a piece of vinyl 5in
2- fold ends in 1/4 and sew them / i sew 2 lines on one end to look a lil better
3- flip inside out and sew together
4- flip right side to and slide it on
i made a full boot for it but didnt like the way it looked

have a bunch of vinyl left from when i made shift boots for my old car club
 

Attachments

·
Registered
Joined
·
92 Posts
Discussion Starter #3
no prob. i can make you one for free if you just cover the shipping? maybe a couple bucks i dont know?? i have all different colors still laying around
 

·
Usual Suspect
Joined
·
1,149 Posts
Wendy - Would you like to try a GEN2 prototype? The Gen 2 E-brake handle grip area is 3 3/4" long and the grip circumference is 4"

Do you have any red that might match the red flame on my shift knob?



Would $10 cover your time & shipping to the Chicago area? U.S, Mail is fine, lower cost and no big hurry.
 

·
Registered
Joined
·
92 Posts
Discussion Starter #8
sounds good to me! pm me . also i will make a few different ones and put them all in there sp you can pick the one that fits best
 
1 - 9 of 9 Posts
Status
Not open for further replies.
Top