Tools needed- 10mm socket, ratchet, extension
TBL cover pull to remove
Remove 2-10mm bolts
Pull OEM TBL out exposing wiring and plug
Unhook wiring from bulb plug by pushing down on lock pin and pull or you
can just pull bulb and wiring out by twisting the bulb housing then pulling out as 1 unit.
Remove the bulb this is where the plug from the Oznium will go.
Wiring on Oznium TBL
Snap Plug from Oznium TBL into bulb housing snap wiring back in place and
put housing into Oz TBL housing twist to lock into place.
Test brake light and put housing back in place if it dosn't light try flipping the plug from the Oz 180 in the bulb housing it will fit in both ways but only light oneway.
Put the housing back into the rear hatch tighten bolts back down and you're done. You may want to paint your bolts black or to color match your ride.
Below a vid I took during installation sorry about the low lighting my bad.
The first few sets were by invitation only but they should have them on their site this week if not see Keith here in club xB he might be able too help you.
Quote:
Originally Posted by saved2live
These aren't on oznium.com
Keith can hook you up I think If he still has them.
Last edited by enuf2spare35 : 02-09-2009 at 02:00 PM.
Reason: Automerged Doublepost
The first few sets were by invitation only but they should have them on their site this week if not see Keith here in club xB he might be able too help you.
Keith can hook you up I think If he still has them.
Glad you liked it...
yea I like getting rid of my extra packing stuff around the house.. haha
Nice pics Benny. I'm loving my 3rd brake light. It's bright as hell and definitely different. It's one of those mods only dedicated xB owners will notice. I like those.
